HP DesignJet T2600 User Guide - Page 202
Paper cannot be loaded successfully, Unsuccessful roll load issues, Unsuccessful sheet load
View all HP DesignJet T2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
Paper cannot be loaded successfully ● Ensure that no paper is already loaded. ● Ensure that the paper is far enough inside the printer: you should feel the printer grab the paper. ● Do not attempt to straighten the paper during the aligning process, unless instructed to do so by the front- panel display. The printer automatically attempts to straighten the paper. ● The paper may be crumpled, or warped, or may have irregular edges. ● It can be difficult to insert a particularly stiff paper from the upper roll. Try moving it to the lower roll. Unsuccessful roll load issues ● If the paper does not load, the leading edge of the paper may not be straight or clean and needs to be trimmed. Remove the initial 2 cm (1 in) from the roll and try again. This may be necessary even with a new roll of paper. ● Ensure the roll ends are tight against the spindle ends. ● Check that the spindle is correctly inserted. ● Check that the paper is correctly loaded on the spindle. See Load a roll onto the spindle on page 41. ● Check that all roll end plugs have been removed. ● Check that the paper is wound tightly on the roll. ● Do not touch the roll or paper at during the alignment process. ● When loading a roll, the roll cover must remain open until the front panel prompts you to close it. If the paper has not been inserted straight, the printer attempts to straighten the roll. If you would like to start the load process again, cancel the process on the front panel and rewind the roll from the end of the spindle until the edge is removed from the printer. NOTE: If the roll has become loose around the core, the printer cannot load the paper. Unsuccessful sheet load ● Guide the sheet, especially thick papers, when the printer initially feeds the sheet. ● Ensure that the sheet is aligned with the reference line on the roll cover. ● Do not attempt to straighten the sheet during the loading process, unless instructed to by the front-panel display. ● Do not use hand-cut sheets, which may be of irregular shapes. Use only purchased sheets. ● Ensure the single sheet is not skewed. In case of any problem, follow the instructions given on the front-panel display. If you would like to start the load process again, cancel the process on the front panel; the printer ejects the sheet. 194 Chapter 16 Troubleshooting paper issues ENWW