HP Integrity Superdome 2 8/16 HP Smart Update Manager 5.0 User Guide - Page 34

Installation options /use_wmi /use_ams /romonly /softwareonly /express_install Description used, the AMS components are required, but the WMI components are optional. This argument specifies that components that use WMI protocol are available for installation. These components are optional and are not installed unless this argument is used. When the /use_wmi argument is used, and the /use_snmp & /use_ams arguments are not, the SNMP and AMS components are optional. This argument does not apply to HP Integrity Servers. This argument specifies that components which Agentless Monitoring service (AMS) components can be installed along with SNMP components. The AMS and SNMP components are available to select by default. When the /use_ams argument is used, the SNMP components are required, and the WMI components are optional. This argument is a filter switch and allows the user to only see the firmware components needed for installation. When using this filter switch, you must exit and restart HP Smart Update Manager if you wish to return to an unfiltered state. Do not use the /romonly argument with the /softwareonly argument.(Applies to firmware only.) This argument is a filter switch and allows the user to only see the software components needed for installation. When using this filter switch, you must exit and restart HP Smart Update Manager if you wish to return to an unfiltered state. Do not use the /softwareonly argument with the /romonly argument. This argument starts express install (for local host only). The HP Smart Update Manager (HPSUM) performs discovery,install, or exit without user interaction. The user can cancel or terminate HP Smart Update Manager. Overriding errors Description /tpmbypass or /ignore_tpm These arguments specifies that if a Trusted Platform Module (TPM) is enabled, the warning message should be ignored and component installation will be allowed to continue. /ignore_warnings This argument allows the installation to proceed on a Superdome 2 target even when warnings are returned during analysis. /continue_on_erro This argument causes the installation to continue and ignore errors. Valid values are : r * =ServerNotFound and * =BadPassword. * =FailedDependencies The ServerNotFound option can be used to bypass inactive or unavailable remote hosts when deploying firmware or software to multiple remote hosts at the same time. /override_existin This argument is used to define the behavior when a remote target has an existing HP g_connection Smart Update Manager session in progress. It overrides the session in progress and reinitializes the installation framework on the remote host. /On_failed_depend This argument provides HP Smart Update Manager the information of ency: how to proceed when a component has a failed dependency. The supported parameters for this argument are Omit_Host (default), Omit_Component and Force. Omit_Host causes the host to be put into a failure state and no installation is attempted. Omit_Component deselects the affected component(s) and proceeds with any updates that do not have dependency failures. Force attempts all updates, even if they have dependency failures. Reboot options /r[eboot] Description If the following conditions are met, this argument causes the server (or host server in a remote installation) to reboot: • The /reboot option is selected or given as a command-line argument. Scripted deployment 34