HP Integrity Superdome SX2000 HP Integrity Servers with Microsoft Windows Serv - Page 39
EFI Boot, Internal Bootable DVD, Enter, Load OEM Boot Driver, Esc 8
View all HP Integrity Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
• Enable greater than 256 interrupts (cell-based servers only) When using Windows Server 2003 on cell-based servers, the system only allows 256 interrupts. To overcome this limitation, apply QFE 900713, then add /EXTINTVEC to the boot options using NVRBOOT. • Disconnect all drives except the boot drive prior to OS installation Only the target operating system drive should be connected during installation. This ensures that the operating system is installed on the correct drive. Make sure that the Z: drive letter is free. Windows Server 2003 with SP1 creates the EFI partition here. HP recommends that you install the boot controller in the root cell. • Default MP/iLO settings for cell-based and entry-level servers For cell-based servers, the MP is assigned a static IP address at the factory before it ships. It is not assigned a DNS name and it is not DHCP enabled. If you are performing a headless server installation, you can connect to the MP over a LAN (instead of using a serial cable) by using this static IP for initial configuration of the MP. The default IP address of a cell-based server's MP is 192.168.1.1. The default user name and password are Admin and Admin. Change the IP address and the default password at installation. For entry-level servers with iLO MPs, the MP is assigned a default DNS name at the factory and is DHCP enabled. It is not assigned a default IP address. The default host name can be deduced from the MP's MAC address. The host name is in the form mpMAC, where MAC is the 12-digit MAC code of the MP's NIC. The MAC address of the MP LAN interface is typically located on a sticker on the back of the server. • Set Cell Local Memory to 100% (cell-based servers only) HP recommends that you set the Cell Local Memory (CLM) parameter to 100% for optimal server performance. • Loading OEM boot drivers Boot drivers can only be installed from the Windows installation CD or a floppy disk. Integrity servers do not have floppy drives, so boot drivers that are not on the Windows CD must be loaded into memory and then installed. EBSU shows devices that it detects and that have a virtual floppy image available. To load the driver: 1. Boot the server. Load the HP Smart Setup CD into the server CD-ROM/DVD drive. 2. From the EFI Boot Menu, select Internal Bootable DVD and press the Enter key. 3. From the main menu, select Load OEM Boot Driver and press the Enter key to continue. 4. Select the boot controller driver to place on the virtual floppy for use during Windows installation. Select OK, and press the Enter key. • Using F8 from a headless console Pressing the F8 key when using a headless console does not work. When prompted to press the F8 key, you must press the Esc 8 key sequence instead. Press the 8 key within two seconds after pressing the Esc key. Otherwise, the system registers only the Esc key and reboots. Tips and Tricks 39