HP LH4r HP Netserver LH 4 User Guide - Page 33
Remove cover 2 see Removing and Replacing Covers.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Chapter 5 Installing Additional Memory 2. Remove cover 2 (see Chapter 3, "Removing and Replacing Covers"). 3. Remove the four screws holding the System board assembly secure on top. Remove the system board assembly by raising the retaining latches to disengage it from the socket, then pull it out until it clears the chassis guides (see Figure 5-5). Set the system board assembly down on a work surface, metal plate side down. Figure 5-5. Removing System Board from LH 4r 4. Loosen the memory cage screw, and remove the cover by sliding it slightly up to unlock it. 5. Unseat each memory board with the release clips, and remove the two boards (see Figure 5-6). 27
Chapter 5
Installing Additional Memory
27
2.
Remove cover 2 (see Chapter 3, "Removing and Replacing Covers").
3.
Remove the four screws holding the System board assembly secure on top.
Remove the system board assembly by raising the retaining latches to
disengage it from the socket, then pull it out until it clears the chassis
guides (see Figure 5-5). Set the system board assembly down on a work
surface, metal plate side down.
Figure 5-5. Removing System Board from LH 4r
4.
Loosen the memory cage screw, and remove the cover by sliding it slightly
up to unlock it.
5.
Unseat each memory board with the release clips, and remove the two
boards (see Figure 5-6).