HP LH4r HP Netserver LH 4 User Guide - Page 99
Marking the Columns
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Appendix A Installing the NetServer in an HP Systems Rack • Hewlett-Packard Systems Rack template • Tape or a marker pen to mark mounting locations Installing the Slides The following steps and illustrations describe how install slides for mounting a NetServer. Marking the Columns Mark the mounting location of the NetServer and mounting holes on each column of the rack as described (see Figure A-2). NOTE The EIA unit marks are stamped in the sheet metal of the columns. tYiou can use the rack template to mark the correct holes for mounting (on all four columns). Marking Front Columns Mark the slide mounting holes on the front columns. 1. Mark the base line (bottom) of the NetServer at an EIA unit mark on the column. 2. Hold the bottom of the rack template at the base line. Mark the top of NetServer (8 EIA units counted up from the base line). 3. Mark the slide screw mounting holes (holes 20 and 22 counted up from the base line). 4. Mark the second front column by repeating steps 1 through 3 and . Marking Rear Columns Mark the slide mounting holes on the inside faces of the rear columns. 1. Mark the base line (bottom) of the NetServer at an EIA unit mark on the column. 2. Hold the bottom of the rack template at the base line. Mark the top of NetServer (8 EIA units counted up from the base line). 3. Mark the slide mounting hole (hole 21 counted up from the base line). 93