HP LH4r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 125
Releasing the Outer-Rail Assembly
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Chapter 13 Alternative Rack Mounting (4-Post) A tension spring allows the outer-rails to compress during installation. The outer-rails are held in place at of the front of the rack by a flat spring tab at the rear face of the front columns. See Figures 13-2 and 13-5. 6. Repeat Steps 3 through 5 for the outer-rail assembly on the right front and rear columns. 7. If you need to release the outer-rail assembly once installed into the rack, do the following: a. Place your finger inside the rail at the point shown by the arrow to release the spring tab. See Figure 13-5. b. Press in on the spring tab and pull the outer-rail assembly toward you at the front of the rack. See Figure 13-5. Spring Tab View Rotated 90 Degrees CCW Figure 13-5. Releasing the Outer-Rail Assembly 119