HP LH4r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 131
Processors, Chipset, Memory, Video, PCI Bus, CD-ROM, Resolution, Max. Refresh, Rate @ 256, Colors
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Appendix A Specifications Table A-4. HP Netserver Hardware Specifications Processors Chipset Memory Video SCSI IDE Intel Pentium III (up to 2 processors) processors, at supported speeds of 1.13 and 1.26 GHz, with 512 KB level 2 cache on processor RCC LE chip set with 133 MHz bus speed support Supports up to four SDRAM DIMMS for a maximum of 4 GB. Supported DIMM types: 128 MB, 256 MB, 512 MB and 1 GB unbuffered (registered), 72 bits wide, ECC single-bit correcting, multi-bit detecting. Supports up to 1600x1200, @ 65K colors, using an Embedded ATI Rage XL video chip with 4 MB SGRAM/SDRAM. Refer to Table A-5, "Video Display Modes" for more details. Embedded Symbios Ultra-160 SCSI dual channel controller; 160 MB/s transfer rate with two 68-pin connectors Embedded Enhanced-IDE dual channel controller LAN PCI Bus Two Embedded Intel 82559 10/100 PCI Fast Ethernet Controllers; with Wake-on-LAN and Alert-on-LAN enabled/disabled via BIOS setup One 32/64-bit, 33 MHz speed, 5 volt PCI slot on riser board I/O CD-ROM One serial/management port and one bi-directional parallel port with ECP/EPP high-speed support; one PS/2 mouse, one PS/2 keyboard, and two USB connectors One Slimline CD-ROM drive; IDE interface; 24x speed Table A-5. Video Display Modes Resolution Max. Refresh Rate @ 256 Colors Max. Refresh Rate @ 65K Colors Max. Refresh Rate @ 16.7M Colors 640x480 800x600 1024x768 1152x864 1280x1024 1600x1200 200 Hz 200 Hz 150 Hz 120 Hz 100 Hz 76 Hz 200 Hz 200 Hz 150 Hz 120 Hz 100 Hz 76 Hz 200 Hz 160 Hz 120 Hz 85 Hz 85 Hz Not available 125