HP LH4r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 54
See remove the air duct.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Chapter 6 Installing an Additional Processor Refer to Chapter 2, "Opening and Closing the HP Netserver," to gain access to the system board. NOTE It is not necessary to remove the system board from the Netserver to install the second processor (CPU 2). 6. Loosen the two captive screws holding the air duct over the DIMM slots and remove the air duct. See Figure 6-2. Figure 6-2. Removing the Air duct 7. Ensure the processor speed of the second processor (CPU 2) is the same as the existing processor before installing the second processor. 48
Chapter 6
Installing an Additional Processor
48
Refer to Chapter 2, "Opening and Closing the HP Netserver," to gain access
to the system board.
NOTE
It is not necessary to remove the system board from the
Netserver to install the second processor (CPU 2).
6. Loosen the two captive screws holding the air duct over the DIMM slots and
remove the air duct.
See Figure 6-2.
Figure 6-2. Removing the Air duct
7. Ensure the processor speed of the second processor (CPU 2) is the same as the
existing processor before installing the second processor.