HP LH4r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 98
Setting the HP Netserver's Boot Passwords, Power-On Password, Hardware Security
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Chapter 10 Configuring the HP Netserver 12. Choose Exit Saving Changes from the list of exit options, then press Enter. A dialog appears and asks you to confirm your decision. 13. Choose Yes and then press Enter. Then the HP Netserver reboots. Setting the HP Netserver's Boot Passwords Use this topic to set a password to boot the HP Netserver. To configure the HP Netserver for a password, which will require a password on boot-up, refer to the following procedure. 1. If not already in the Setup Utility, boot or reboot the system and press F2 when prompted. 2. Use the right-arrow or left-arrow key to select Security from the menu bar. As soon as it is selected, the selections for the Security menu appear as shown below. ➢Power-On Password ➢Hardware Security The arrowhead ➢ indicates there is a submenu to select from. 3. If necessary, use the arrow key to move to the Power-On Password menu selection and press Enter. The Power-On Password is highlighted by default when the Security menu is selected. The first line in the menu is, "Power-on password is [Set or Not Set]" a. If no password has been set, then "Not Set" will appear in the field. If this is the case, then you can boot the Netserver without a password. The Power-on password controls access to the Setup Utility and its settings, but will not be in effect until you reboot the Netserver. b. If "Set" is in the field, then you can change the password or remove the password, if you know the exiting password. If you do not know the existing password, then refer to "Resetting a Lost Password" in Chapter 12, "Troubleshooting." NOTE You must set the Power-on Password to configure the HP Netserver to boot with a password. 92