HP LH4r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 90
Connecting the UPS (Uninterruptible Power Supply), in Setup BIOS Utility.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Chapter 9 Connecting the Monitor, Keyboard, Mouse, and UPS Connecting the UPS (Uninterruptible Power Supply) 1. If you do not have an UPS (Uninterruptible Power Supply) located in the rack, install it before attempting to connect it to the Netserver. 2. Connect the serial cable provided between the UPS and the HP Netserver. Refer to the user guide included with the UPS for additional information and ensure you configure the Netserver's serial/management port correctly in Setup (BIOS) Utility. NOTE The HP Netserver's serial/management port must be configured correctly or the UPS and Netserver may not work correctly. 3. If you have connected the serial cable between the two devices, turn on the UPS. The HP Netserver LP 1000r performs a diagnostic test when the power switch is turned on. If an error condition occurs, note any error code appearing on the display, then refer to Chapter 12, "Troubleshooting." 84