HP LH4r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 45
Bit PCI Slot 1, Riser Board not shown, Connector, System Board top view, Refer to the Readme file
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter 5 Installing Additional Boards NOTE Refer to the Readme file, Tested Products List, or Configuration Advisor on your HP Netserver Navigator CD-ROM for helpful information about a particular PCI board type. 64-Bit PCI Slot (1) Riser Board (not shown) I2C Connector System Board (top view) Figure 5-2. PCI Accessory Board Slot NOTE Refer to "System Board Layout" in the Appendix A, "Specifications," for connections not shown in Figure 5-2. 7. Lift and rotate the securing clamp up to about a 45° angle. See Figure 5-3. The securing clamp holds the riser board in place and helps secure the PCI board. 39
Chapter 5
Installing Additional Boards
39
NOTE
Refer to the Readme file, Tested Products List, or
Configuration Advisor on your
HP Netserver Navigator
CD-ROM
for helpful information about a particular PCI board
type.
64-Bit PCI Slot (1)
Riser Board (not shown)
IC
Connector
2
System Board (top view)
Figure 5-2. PCI Accessory Board Slot
NOTE
Refer to "System Board Layout" in the Appendix A,
"Specifications," for connections not shown in Figure 5-2.
7. Lift and rotate the securing clamp up to about a 45
°
angle. See Figure 5-3.
The securing clamp holds the riser board in place and helps secure the PCI board.