HP LaserJet Pro CP1525 HP LaserJet Pro CP1520 - User Guide - Page 137
Press [OK], Supplies low
View all HP LaserJet Pro CP1525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Control panel message Misprint Press [OK] Non HP supply installed Status alert Print failure Press [OK] If error repeats turn off then on Rear door open Remove shipping locks from cartridge Remove shipping locks from all cartridges Replace Supplies low Unexpected size in tray # Load [size] Press [OK] ENWW Description Paper has been delayed as it moves through the product. Recommended action Press OK to clear the message. A non-HP supply is installed. If you believe you purchased an HP supply, go to www.hp.com/ go/anticounterfeit. Service or repairs that are required as a result of using nonHP supplies are not covered under HP warranty. The product cannot process the Press OK to continue printing the page. job, but output might be affected. If the error persists, turn the power off and then on. Resend the print job. The product rear door is open. Close the door. A print cartridge shipping lock is Be sure that the print cartridge installed. shipping lock has been removed. A print cartridge shipping lock is installed on one or more print cartridges. Be sure that each print cartridge shipping lock (orange pull tab on the left end of new print cartridges) has been removed. The print cartridge is at the end of its useful like, and the At Very Low menu item in the System Setup menu is set to Stop. To ensure optimal print quality, HP recommends replacing the print cartridge at this point. You can continue printing until you notice a decrease in print quality. Actual cartridge life may vary. Once an HP supply has reached "very low", HP's premium Protection Warranty on that supply has ended. All print defects or cartridge failures incurred when an HP supply is used in continue at very low mode will not be considered to be defects in materials or workmanship in the supply under the HP Print Cartridge Warranty Statement. More than one supply item is low. Check the supply level gauges on the control panel, or print a supplies status page to determine which print cartridges are low. Printing will continue until a "Very Low" message displays. Consider having replacement supplies on hand. The product has detected paper Load the correct paper into the in the tray that does not match the tray, or configure the tray for the configuration for the tray. size that you have loaded. Interpret control panel messages 123