HP StorageWorks MSA1510i HP Storage Management Utility user guide (383075-002, - Page 74
Enabled, that is in a different subnet than the data ports, Port State, Host Name, Logical Port Name
View all HP StorageWorks MSA1510i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
8. In the Management Settings window, enter settings for the management port. NOTE: • Port State must be Enabled (default) to use the SMU. To re-enable SMU management, you must use a Command Line Interface (CLI) command. For more information, see the Command Line Interface user guide. • Assign a Host Name to the storage system. (Default: chassis serial number) • By default, the wizard suggests configuring Logical Port Name MA0 as the primary management port. HP recommends accepting the default. • To control the path of management traffic to and from the array controller, and to add one level of system security, HP recommends assigning a static IP address to the management port that is in a different subnet than the data ports. To assign a static IP address, expand the DHCP Setting drop-down box and change the setting to Disabled. The page expands (shown), showing the currently assigned IP address. Change this to the address you want to use for management traffic. After changing the IP address, you may need to re-connect to the SMU, using the newly assigned IP address. • VLANs are set up on the switch and are used as one method of controlling access to the storage. If using VLANs, enter the VLAN ID to use (0 = not used). 74 Wizards