HP Surestore Tape Library Model 2/15 HP DLT Tape Library 15-Slot - (English) U - Page 37

Failure to extend the antitip rail could result in personal injury

Page 37 highlights

WARNING Figure 2-3 Library Installation Step 6: Connect Library to Host 2. Extend the rack's antitip rail and verify that the leveller feet are down. Failure to extend the antitip rail could result in personal injury and/or damage to the library if the rack tips over. 3. Use the key to open the front access door. Remove the two screws that secure the library to the rack. Front Access Door Library Installation 4. Slide the library out of the rack so that it is in the fully extended position. 5. Gently pull the SCSI and power cables back toward the rear of the rack. Use a cable tie to secure them to the rail at the back of the rack. The cable tie should be at about the same height as the top of the library. 2-11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114

2-11
Library Installation
Step 6: Connect Library to Host
Library Installation
2.
Extend the rack’s antitip rail and verify that the leveller feet are down.
WARNING
Failure to extend the antitip rail could result in personal injury
and/or damage to the library if the rack tips over.
3.
Use the key to open the front access door. Remove the two screws that
secure the library to the rack.
Figure 2-3
Front Access Door
4.
Slide the library out of the rack so that it is in the fully extended position.
5.
Gently pull the SCSI and power cables back toward the rear of the rack.
Use a cable tie to secure them to the rail at the back of the rack. The cable
tie should be at about the same height as the top of the library.