HP Surestore Tape Library Model 2/15 HP DLT Tape Library 15-Slot - (English) U - Page 96
Reserved, Do Inventory Test, Inventory Check
![]() |
View all HP Surestore Tape Library Model 2/15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Library Operation Troubleshooting Table 4-11 Troubleshooting (Continued) Problem Solution Cannot remember the administration menu password. First, try the default password (000-000-000). If the default is not accepted, call a service representative for assistance. Attempted to open the front access door, but a RESERVED message displays. Started a test and need to stop. • The host may have reserved an element and must unreserve it. Refer to the host system documentation to unreserve a tape. • A security configuration was set to prevent cartridge removal. See "SECURE ON/OFF" in the list of configurations found in "Setting Configuration Options" on page 4-24. Press CANCEL. The current test loop continues until finished, then the test stops. DO INVENTORY TEST displays (initialize element status). • Power cycle the library by pressing the power switch off and then on again. (See the caution note at the end of this table.) • Run the INVENTORY CHECK test under the TEST* menu. Cannot write to the tape. Cannot read the tape. • Check the host file system access permissions. • Check the write-protect tab on the cartridge to assure write-enabled status. • Check the application software. • Check the host file system access permissions. • Verify that the correct tape type is used (See "Choosing Tape Cartridges" on page 3-3.) • Check the application software. CAUTION Do not press the library power switch until all SCSI peripherals connected to host are shut down. Pressing the power button when the SCSI system is active can cause data loss and/or problems with the SCSI interface. 4-46
![](/manual_guide/products/hewlettpackard-surestore-tape-library-model-215-hp-dlt-tape-library-15slot-english-user039s-guide-6c66723/96.png)