HP t530 Hardware Reference Guide - Page 13

Mounting and orienting the thin client, HP Quick Release

Get HP t530 PDF manuals and user guides View all HP t530 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Mounting and orienting the thin client HP Quick Release An optional Quick Release mounting bracket is available from HP for mounting the thin client to a wall, desk, or swing arm. When the mounting bracket is used, do not install the thin client with the I/O ports oriented towards the ground. This thin client incorporates four mounting points on the right side of the unit. These mounting points follow the VESA (Video Electronics Standards Association) standard, which provides industry-standard mounting interfaces for Flat Displays (FDs), such as flat panel monitors, flat displays, and flat TVs. The HP Quick Release connects to the VESA-standard mounting points, allowing you to mount the thin client in a variety of orientations. NOTE: When mounting to a thin client, use the 10 mm screws supplied with the HP Quick Release. To use the HP Quick Release: 1. Lay the thin client down with the right side up and the front side with the HP logo facing you. 2. Press the left side (1) of the side cover down, and then lift the side cover (2) off the thin client. NOTE: Retain the side cover for possible future use. Setup 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
Mounting and orienting the thin client
HP Quick Release
An optional Quick Release mounting bracket is available from HP for mounting the thin client to a wall, desk,
or swing arm. When the mounting bracket is used, do not install the thin client with the I/O ports oriented
towards the ground.
This thin client incorporates four mounting points on the right side of the unit. These mounting points follow
the VESA (Video Electronics Standards Association) standard, which provides industry-standard mounting
interfaces for Flat Displays (FDs), such as flat panel monitors, flat displays, and flat TVs. The HP Quick Release
connects to the VESA-standard mounting points, allowing you to mount the thin client in a variety of
orientations.
NOTE:
When mounting to a thin client, use the 10 mm screws supplied with the HP Quick Release.
To use the HP Quick Release:
1.
Lay the thin client down with the right side up and the front side with the HP logo facing you.
2.
Press the left side (1) of the side cover down, and then lift the side cover (2) off the thin client.
NOTE:
Retain the side cover for possible future use.
Setup
7