Icom MR-1220 Instruction Manual - Page 63
Resetting to the defaults, Settings Reset, Factory Reset
View all Icom MR-1220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Settings for a maintenance DDResetting to the defaults When you reconfigure your settings, you can reset the radar settings to the factory defaults. There are 2 types of resetting. Select an appropriate way, according to your situation. •• Settings Reset Resets settings other than in the Initial menu. •• Factory Reset Resets all the settings to the factory defaults. NOTE: You can reset the settings only in the Standby mode. 1. Confirm the radar is in the Standby mode, if necessary, push [TX (SAVE)]/[ ] to enter the Standby mode. 2. Select "Settings Reset" or "Factory Reset" in the Initial menu. [MENU]/[ ] > Initial > Settings Reset [MENU]/[ ] > Initial > Factory Reset 3. Push [ENTER OK> and are displayed. 4. Push [◄] to select , and then push [ENTER]/ [ ] to reset the settings. •• After Factory Reset has been done, the radar automatically restarts and the Initial screen as shown below is displayed. Select a language, and then push [ENTER]/ [ ] to boot up the radar. LLThe selectable language differs, depending on the display unit version. Maintenance 10 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 58