Intermec PB22 PB22 and PB32 Mobile Label and Receipt Printer User Guide - Page 53
Configuring Wireless Printing Using Fingerprint, To con the printer to use WEP authentication
View all Intermec PB22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Chapter 2 - Configuring the PB22 and PB32 • Send this command to make sure your values match those used by the access point: wt,[variable name] All variables are returned with the exception of EAP_PASS which always returns "****" if configured and CA_CERT which transmits the name of the last certificate authority successfully installed. An additional read-only variable for the supplicant state, called STATE, is also returned. • You may need to send this command several times for the wireless station to connect: ws,ACTIVE,1 Configuring Wireless Printing Using Fingerprint Use these procedures to configure your printer with Fingerprint for wireless printing. To configure the printer to use WEP authentication 1 Send these commands to login as an admin and set the SSID: run"su -p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. Note: The default password for logging in as an admin is "pass." If you changed the password, you need to use your password instead of "pass." 2 Send these commands to configure the WEP keys. This example sets WEP key 1 to 1234 and enables WEP key 1. setup "wlan","WEP1","0x0001020304" setup "wlan",".WEP_KEY","1" setup "wlan","ACTIVE","1" setup write "wlan","uart1:" To configure the printer to use WPA-PSK or WPA2-PSK mode 1 Send these commands to login as an admin and set the SSID: run"su-p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. PB22 and PB32 Mobile Label and Receipt Printer User Guide 41