Intermec SF51 SF51 Cordless Scanner User's Guide - Page 39
Troubleshooting the SF51 continued - battery troubleshooting
View all Intermec SF51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Chapter 3 - Troubleshooting and Maintaining the SF51 Troubleshooting the SF51 (continued) Problem Possible Solution You are trying to The SF51 may not be in a discoverable state. For help, establish a Bluetooth see "Bluetooth Discoverable" on page 39. connection from a host device to your SF51, but the host device cannot find your SF51. The SF51 may be connected and paired to another Bluetooth device. Scan the following bar code to reset the SF51 to its default settings and disconnect Bluetooth communications. Try establishing a connection again. Using the Administrator Reset Factory Defaults command resets all settings. As a result, you will lose Bluetooth communications. Administrator Reset Factory Defaults \60\08\55\22 When you press the Scan button, the red scanner beam does not turn on. The battery is low. Charge the battery immediately and try scanning again. You changed the Bluetooth PIN from its default value of 0000, but you forgot your new PIN number. Scan this bar code to reset the scanner to its default configuration and default Bluetooth PIN of 0000. Administrator Reset Factory Defaults You established a Bluetooth connection with an Intermec computer, and the settings on your SF51 were restored to their default values. \60\08\55\22 When you connect to an Intermec computer, all SF51 settings that are common to the Intermec computer's internal scanner settings are changed to the default settings of the internal scanner. Scan configuration bar codes, or use Intermec Settings on your Intermec computer to change your SF51 settings. 26 SF51 Cordless Scanner User's Manual