Intermec SF51 SF51 Cordless Scanner User's Guide - Page 64

Chapter 4 - Configuration Command Reference Trigger Mode Pulse Pulse Turn Off After Good Read SF51 Behavior Enabled Disabled The SF51 turns off after it successfully reads a bar code. The SF51 stays on until the Trigger Timeout period is reached. UPC/EAN Enables or disables decoding of Universal Product Code (UPC)/ European Article Numbering (EAN) symbology. UPC/EAN are fixed-length, numeric, continuous symbologies that use four element widths. A scanner that is configured to decode EAN bar codes can decode UPC, but the reverse is not true. UPC code is a subset of EAN code. ISBN ISBN (International Standard Book Number) is a 10-digit symbology that uniquely identifies books for tracking and ordering. With ISBN enabled, the first three characters (978) are ignored, and the checksum is calculated on the remaining characters. GTIN Processing With GTIN (Global Trade Item Number) processing enabled, two zeros are padded to the beginning of UPC-A, and one zero is padded to the beginning of EAN-13 to expand the numbers to 14 digits. To use GTIN processing you also need to enable the corresponding UPC/EAN symbology. User Reset Factory Defaults Causes the SF51 to perform a restart and restores all configuration commands to their default settings, only if no settings are locked. To reset all settings on the SF51, including locked settings, use the Administrator Reset Factory Defaults command. For more information, see "Administrator Reset Factory Defaults" on page 38. When you restore all configuration commands to their default settings, you need to reestablish Bluetooth communications. SF51 Cordless Scanner User's Guide 51