Intermec SF51 SF51 Cordless Scanner User's Guide - Page 63
Trigger Timeout, Turn Off After Good Read
View all Intermec SF51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Chapter 4 - Configuration Command Reference Mode Pulse Flashing Autostand Aim Description When you press the Scan button, the red scanner beam turns on. The scanner remains on until the Trigger Timeout period is reached. When you press the Scan button, the red scanner beam turns on and the SF51 checks for a bar code to read. When the Trigger Timeout period is reached, the scanner starts flashing. When the SF51 finds and reads a bar code, it resets the Trigger Timeout period. If you press the Scan button a second time, the scanner turns off. Autostand mode allows you to switch between level mode and flashing mode. The first time you press the Scan button, the scanner beam turns on and the scanner is in flashing mode. You switch to level mode by pressing the Scan button again. If the scanner is idle and the Trigger Timeout period is reached, the scanner returns to flashing mode. Aim triggering allows you to turn on the scanner and aim the red scanner beam without causing a decode. Releasing the Scan button enables the decode. Note: EasySet contains a folder, Predefined Modes, in Operating Settings > Trigger Activation. The commands in this folder are currently not supported on the SF51. Trigger Timeout Set the Trigger Timeout for the Trigger Mode command. You can set Trigger Timeout from 1 to 4095 seconds. Turn Off After Good Read Sets how the SF51 operates in level and pulse trigger modes. Trigger Mode Level Level Turn Off After Good Read SF51 Behavior Enabled Disabled The SF51 turns off after it successfully reads a bar code. The SF51 stays on until you release the Scan button. 50 SF51 Cordless Scanner User's Guide