Intermec SF51 SF51 Cordless Scanner User's Guide - Page 56

Chapter 4 - Configuration Command Reference Configuration Modes and Utilities Use Configuration Modes and Utilities to: • allow the SF51 to always accept configuration commands by scanning bar codes or to timeout 1 minute after the last configuration command is set by scanning a bar code. • get the product version, sub-system versions, and Bluetooth address of your SF51. • page the SF51 from your host PC or turn off the SF51. For more information and bar codes, see "Calling Product Support" on page 24. Consecutive Same Read Data Validation To increase decode security, you can have the scanner scan a bar code multiple times to ensure you have a valid read before transmitting the data. You can set Consecutive Same Read Data Validation from 0 to 10. The default value of 0 sets the scanner to automatically adapt the consecutive same read based on the bar code quality and the trust level of the bar code. For example, labels with a check digit require less reads than labels without a check digit. Data Editing Data editing allows you to edit data scanned by the SF51 before it is transmitted to your host. You can define up to seven input scenarios to filter out the data you want to edit. For more information, see the EasySet software. Disable All Symbologies This command disables all symbologies. Disabling all symbologies does not reset symbology parameters to their default values. To reset all symbology parameters to their default factory settings, use the Administrator Reset Factory Defaults command. For more information, see "Administrator Reset Factory Defaults" on page 38. SF51 Cordless Scanner User's Guide 43