Intermec SF51 SF51 Cordless Scanner User's Guide - Page 51
SF51 Configuration Commands
View all Intermec SF51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Chapter 4 - Configuration Command Reference Command Configuration modes and utilities Bluetooth device page Default Value Configuration Enabled N/A See Page 43 39 SF51 Configuration Commands This section lists the configuration commands in alphabetical order and provides a description of each command. To configure your SF51 using these commands, see the EasySet software. Administrator Reset Factory Defaults Causes the SF51 to perform a restart and restores all configuration commands to their default settings. When you restore all configuration commands to their default settings, you need to reestablish Bluetooth communications. Beep Duration Sets the length of the beeps. You can set Beep Duration to a value from 0 to 2550 ms. When Beep Duration is set to 0 ms, the beeper is off. Turning off the beeper does not affect the beeps associated with Bluetooth Connect/Disconnect or Bluetooth Device Page. Use Beep Duration in combination with Beep Frequency and Beep Volume to define beeps according to operator preference and work environment. Beep Frequency Sets the frequency, or pitch, of the beeps. You can set Beep Frequency to a value from 1000 to 5110 Hz. Use Beep Frequency in combination with Beep Volume and Good Read Beep Duration to define beeps according to operator preference and work environment. 38 SF51 Cordless Scanner User's Guide