JVC DLA-RS45U Command Communication Specification for D-ILA Projectors (v1.7 f - Page 39

4 Command control Reference Operation Command Parameter Code 1 Function Data type Model 'P' 'M' 'C' 'P' isf Calibration Mode, Picture mode copy 'P' 'M' 'P' 'A' isf Calibration Mode, Picture mode paste 'P' 'M' 'S' 'V' isf Calibration Mode, Picture mode save (*6) 'P' 'M' 'L' 'D' isf Calibration Mode, Picture mode load (*7) 'P' 'M' 'T' 'H' THX Adjustment Mode switch 'T' 'H' 'C' 'P' THX Adjustment Mode, Picture mode copy 'T' 'H' 'P' 'A' THX Adjustment Mode, Picture mode paste 'T' 'H' 'S' 'V' THX Adjustment Mode, Picture mode save (*8) 'T' 'H' 'L' 'D' THX Adjustment Mode, Picture mode load (*9) - Special4 - - Special4 - - Special5 - - Special5 - Special - - - Special6 - - - Special6 - - - Special7 - - - Special7 - - Always available regardless of the adjustment mode except Picture mode is isf-DAY/ isf-NIGHT/ THX-Bright /THX-Dark. (*1) Only the parameter that follows Picture Mode is effective. (Refer to the table of Picture Mode vs. Color Profile that described in "Color Profile" section of Functional Spec.) [Example] Picture Mode = Natural Video(0x38) -> Accepted, Anime1(0x36) -> Rejected Picture Mode = Film Film1(0x31) -> Accepted, Standard(0x33) -> Rejected If the corresponded parameter is only one, PJ ignores setting command. (*2) Setting operations of Mask Left / Right / Top / Bottom [ISML, ISMR, ISMT, ISMB] command are only effective when Mask Setting [ISMA] is set to "Custom". (*3) Because of electrical limitation, only one motor can be driven at the same time. If the projector receives a motor drive request when other motor is driving, the projector rejects its request. When a driving motor reaches its limit, the projector stops the motor automatically. (*4) Parameter is equal to the result in which 100 is multiplied with the actual value. [Example] When Horz. Frequency is 63.98 kHz : Parameter = 63.98 * 100 = 6398 = 0x18FE (*5) Both commands are completely same. (*6)Save of picture adjust mode for isf [PMSV] command is olly effective when isf Adjust mode [PMIE] is Enable(0x31) or Adjust(0x32). (*7) Load of picture adjust mode for isf [PMLD] command is olly effective when isf Adjust mode [PMIE] is Adjust(0x32). And, this command can use regardless of Picture Mode setting. (*8) Save of picture adjust mode for THX [THSV] command is olly effective when THX Adjust mode [PMTH] is Enable(0x31) or Adjust(0x32). (*9) Load of picture adjust mode for THX [THLD] command is only effective when THX Adjust mode [PMTH] is Adjust(0x32). And, this command can use regardless of Picture Mode setting. (*10) Effective when THX Mediadirector switch is On(0x31) 39 / 80 PJ03220107B