JVC GR-DV3000U Instructions - Page 18

18 EN Power lamp Power Switch Tally lamp (lights while recording is in progress) Lock Button Recording Start/Stop Button Display 2 5 min During shooting min (Now calculating) Tape remaining time indicator (Approximate) BR I GHT 90 min 89 min 3 min 2 min (Blinking) 1 min (Blinking) 0 min (Blinking) VIDEO/MEMORY Switch 180° 90° BASIC RECORDING Recording On Tape NOTE: You should already have performed the procedures listed below. If not, do so before continuing. ● Power (੬ pg. 8) ● Grip Adjustment (੬ pg. 10) ● Viewfinder Adjustment (੬ pg. 10) ● Load A Cassette (੬ pg. 12) ● Recording Mode Setting (੬ pg. 15) 1 Press in the tabs on the lens cap to remove it. Press PUSH OPEN, open the LCD monitor and set the VIDEO/MEMORY Switch to "VIDEO". 2 Set the Power Switch to " " or " " while pressing down the Lock Button located on the switch. Shooting while using the viewfinder: Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully. • Be sure to pull out the viewfinder until you hear a click, otherwise it may be pushed back in during use. Shooting while using the LCD monitor: Make sure the LCD monitor is fully open and the viewfinder is pushed back in. Tilt the LCD monitor upward/ downward for best viewability. • The power lamp lights and the camcorder enters the Record-Standby mode. "PAUSE" is displayed. 3 Press the Recording Start/Stop Button. " " appears while recording is in progress. To Stop Recording press the Recording Start/Stop Button. The camcorder re-enters the Record-Standby mode. To Adjust The Brightness Of The Display ..... rotate the MENU wheel until the bright level indicator on the display moves and the appropriate brightness is reached. • When using the viewfinder, it is also possible to adjust the brightness in this same manner. PUSH OPEN Button MENU Wheel