JVC GR-DV3000U Instructions - Page 95
E01, E02 or E06 appears.
UPC - 046838160585
View all JVC GR-DV3000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
EN 79 SYMPTOM P An unusual mark appears. POSSIBLE CAUSES ---- a An error indication (E01, E02 or E06) appears. • A malfunction of some kind has occurred. In this case the camcorder's functions become unusable. s An error indication (E03 or E04) appears. • A malfunction of some kind has occurred. In this case the camcorder's functions become unusable. d The charger indicator on the AC Power Adapter/ Charger does not light. • The temperature of the battery is extremely high/low. • Charging is difficult in places subject to extremely high/low temperatures. f Picture does not appear on the LCD monitor. • The viewfinder is pulled out. • The LCD monitor's brightness setting is too dark. g When the image is printed from the printer, a black bar appears at the bottom of the screen. • This is not a malfunction. h When the camcorder is connected via the DV connector, the camcorder does not operate. • The DV cable was plugged/ unplugged with power turned on. j The memory card cannot be removed from the camcorder. ---- CORRECTIVE ACTION • Check the section of the manual that explains LCD monitor/ viewfinder indications (੬ pg. 84 - 88). • Remove the power supply (battery pack, etc.) and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains even though you repeat the above two or three times, please consult your nearest JVC dealer. Do not eject the cassette. This will cause damage to the tape. • Eject the cassette once and reinsert it, then check if the indication clears. When it does, you can resume using the camcorder. If the indication remains even though you repeat the above two or three times, please consult your nearest JVC dealer. • To protect the battery, it is recommended to charge it in places with a temperature of 10°C to 35°C (50°F to 95°F) (੬ pg. 89). • Push the viewfinder back in. • Adjust the brightness of the LCD monitor (੬ pg. 18). • If the monitor is tilted upward 180 degrees, open the monitor fully (੬ pg. 18). • By recording with "DIS" activated (੬ pg. 29) this can be avoided. • Turn the camcorder's power off and on again, then operate it. • Push in the memory card a few more times (੬ pg. 13).