JVC GR-DV3000U Instructions - Page 76

76 EN TROUBLESHOOTING (cont.) SYMPTOM POSSIBLE CAUSES * During R.A.Edit, the Picture Wipe and Dissolve functions do not work. • The last selected editing scene is ending. • At the end of the last selected scene for editing, the Power switch was set to "OFF". • The power is off. CORRECTIVE ACTION • Select Picture Wipe or Dissolve before beginning editing. The effects are then automatically activated (੬ pg. 68). • Do not turn off the camcorder's power after setting Edit-In and EditOut points, as they will all be erased (੬ pg. 68). • The camcorder automatically shuts off after 5 minutes have elapsed in the Pause mode. Make sure you continue operations within 5 minutes after engaging Pause mode (੬ pg. 68). ( Scene transition does not go as expected. • When using "Picture Wipe/Dissolve" (੬ pg. 68), there is a delay of a fraction of a second between the previous record stop-point and the Dissolve start-point. This is normal, but this slight delay becomes especially noticeable when shooting fast-moving subject or during rapid panning. ---- ) White Balance cannot be activated. • The Sepia or Monotone mode is activated. • Turn off Sepia or Monotone before setting White Balance (੬ pg. 39, 41). q When shooting a subject illuminated by bright light, vertical lines appear. • This is a result of exceedingly high contrast, and is not a malfunction. ---- w When the screen is under direct sunlight during shooting, the screen becomes red or black for an instant. • This is not a malfunction. ---- e During recording, the date/ time does not appear. • "DATE/TIME" is set to "OFF" in the Menu Screen. • Interface Shooting is performed. • Set "DATE/TIME" to "ON" in the Menu Screen (੬ pg. 31). • During Interface Shooting, the date/time does not appear (੬ pg. 19). r Files stored on the memory • Files stored on the memory card card cannot be deleted. are protected. • Remove protection from the files stored on the memory card and delete them (੬ pg. 49, 50).