JVC GR-DV3000U Instructions - Page 38

38 EN NOTES: ● During Night-Alive, the following functions or settings cannot be activated and its indicator blinks or goes out: • Some modes of "Program AE With Special Effects" (੬ pg. 38, 39). • "GAIN UP" in the CAMERA Menu (੬ pg. 29). • "DIS" in the MANUAL Menu (੬ pg. 29). ● During Night-Alive, it may be difficult to bring the camcorder into focus. To prevent this, use of manual focus and/or a tripod is recommended. Power Switch ADVANCED FEATURES (cont.) Night-Alive Makes dark subjects or areas even brighter than they would be under good natural lighting. Although the recorded image is not grainy, it may look as if it is strobing due to the slow shutter speed. 1 Set the Power Switch to " " while pressing down the Lock Button located on the switch. Pull out the viewfinder fully or open the LCD monitor fully. 2 Press NIGHT so that the Night-Alive indicator " " appears. • The shutter speed is automatically adjusted to provide up to 30 times sensitivity. • "A" appears beside " " while the shutter speed is being automatically adjusted. To Deactivate Night-Alive press NIGHT again so that the Night-Alive indicator disappears. Lock Button PROG.AE Button NIGHT Button MENU Wheel Display SHUT TER1/100 S POR T S SNOW SPOT L I GHT TW I L I GHT SEP I A MONOTONE CLASS I C F I LM S T ROBE Menu Screen Program AE With Special Effects 1 Set the Power Switch to " " while pressing down the Lock Button located on the switch. Pull out the viewfinder fully or open the LCD monitor fully. 2 Press MENU wheel in. The Menu Screen appears. 3 Rotate the MENU wheel to select " PRO- GRAM AE", then press it. 4 Rotate the MENU wheel to select the desired mode (੬ pg. 39), then press it. Selection is complete. 5 Press the MENU wheel in again. The Menu Screen closes. 6 Press PROG.AE so that the selected effect indicator appears. To Deactivate The Selected Mode press PROG.AE again so that the effect indicator disappears. NOTES: ● Program AE with special effects can be changed during recording or during Record-Standby. ● Some modes of Program AE special effects cannot be used during Night-Alive. IMPORTANT Some modes of Program AE with special effects cannot be used with certain Fade/Wipe Effects (੬ pg. 37). If an unusable mode is selected, its indicator blinks or goes out.