JVC GR-DV3000U Instructions - Page 71
Insert Editing
UPC - 046838160585
View all JVC GR-DV3000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Display 6w 12: 34 Power Switch Lock Button REW STOP Remote sensor START/STOP INSERT PLAY PAUSE EN 71 Insert Editing You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged. NOTES: ● Before performing the following steps, make sure that "TIME CODE" is set to "ON" in the Menu Screen (੬ pg. 31, 33). ● Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape. ● To perform Insert Editing while watching in the television, make connections (੬ pg. 54). 1 Play back the tape, locate the Edit-Out point and press PAUSE (6). Confirm the time code at this point (੬ pg. 31, 33). 2 Press REW (2) until the Edit-In point is located, then press PAUSE (6). 3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). "6w" and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode. 4 Press START/STOP to begin editing. • Confirm the insert at the time code you checked in step 1. • To pause editing, press START/STOP. Press it again to resume editing. 5 To end Insert Editing, press START/STOP, then STOP (5). NOTES: ● Program AE with special effects (੬ pg. 38, 39) can be used to spice up the scenes being edited during Insert Editing. ● During Insert Editing, the date and time information changes. ● If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas. ● During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops (੬ pg. 87, 88). ● If a memory card is loaded and "NAVIGATION" is set to "ON", a NAVIGATION thumbnail image is stored in the memory card (੬ pg. 42).