Kodak I840 User Guide - Page 29

Setting the elevator tray position, Operator Control Panel.

Get Kodak I840 - Scanner Firmware - PC PDF manuals and user guides
UPC - 041778263082
View all Kodak I840 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

4. Select Return. 5. Use the up and down arrows to select the desired SCSI termination setting. 6. Select Return. 7. Turn the scanner off. Wait at least 10 seconds and turn the scanner back on again. The new termination setting will take effect. Setting the elevator tray position This setting allows you to select a position of the elevator tray. Elevator positions can be set to accommodate 25-, 250-, 500-, 750- or 1000documents (20-lb bond paper). The position will remain as selected unless the Override Elevator icon ( ) is selected. NOTE: The setting of 25 should be used for manual or continuous feed operation. To set the elevator tray position: 1. Select the Diagnostics Settings menu icon. 2. Use the right or left arrow to navigate to the Settings function. 3. Press the down arrow until Set elevator position is displayed on the Operator Control Panel. 3-12 A-61169 July 2003

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
3-12
A-61169
July 2003
4. Select
Return
.
5.
Use the up and down arrows to select the desired SCSI termination
setting.
6. Select
Return
.
7.
Turn the scanner off. Wait at least 10 seconds and turn the scanner
back on again. The new termination setting will take effect.
Setting the elevator tray
position
This setting allows you to select a position of the elevator tray. Elevator
positions can be set to accommodate 25-, 250-, 500-, 750- or 1000-
documents (20-lb bond paper). The position will remain as selected
unless the Override Elevator icon (
) is selected.
NOTE: The setting of 25 should be used for manual or continuous feed
operation.
To set the elevator tray position:
1. Select the Diagnostics Settings menu
icon.
2.
Use the right or left arrow to navigate to the Settings function.
3. Press the down arrow until
Set elevator position
is displayed on the
Operator Control Panel.