Kodak I840 User Guide - Page 76
Multi-feed cal unsuccessful, Multi-feed failed self test
UPC - 041778263082
View all Kodak I840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Message Message Action Message Action Message Action Message Action Message Action Message Action Message Action Message Action Message Action Message Action Message Action Description Mechanical cal unsuccessful The mechanical calibration was unsuccessful. Be sure the correct calibration target was used and that the arrows on the target were feed into the transport first. See Chapter 3, Operator Control Panel Functions, "Calibration" for more information. Motor self test failed The self-test of the paper transport motor failed. Perform a controlled power-down sequence on the scanner. If the problem persists, call Service. Multi-feed count: Informational message. Displays the multi-feed count from the "Count only" mode. Multi-feed detected A multi-feed has been detected due to a length checking condition or an ultrasonic multi-feed condition. Depending on how your scanner is programmed, you may need to restart the scanner from your host computer. Always check your host monitor to verify images as overlapped documents may need to be rescanned. This condition may be caused by poor document separation; replace the separation roller tires and pre-separation pad. See Chapter 5, Maintenance for instructions. Multi-feed failed self test A multi-feed detection subsystem has failed self-test. You can still scan documents, but multi-feed detection will not work. Perform the self-test again or a controlled power down sequence. If the problem persists, call Service. Multi-feed cal unsuccessful The multi-feed calibration failed. Be sure the sensors are clean and that the correct calibration target is used. Retry calibration. See Chapter 5, Maintenance, "Cleaning the Transport area" for cleaning procedures. See the diagram at the end of this document for the approximate location of sensors. Also see Chapter 3, Operator Control Panel Functions, "Calibration" for more information. No paper in tray An attempt was made to start the scanner with no paper in the elevator tray. Place paper in the elevator tray and restart. Page count: Informational message. Displays the page count from the "Count only" mode. Patch count: Informational message. Displays the number of documents containing a patch from the "Patch Test" mode. Patch hardware not present The Patch Reader head is not properly connected to the scanner. Be sure the patch head is properly seated in position and try again. If the problem persists, call Service. Power-on self-test succeeded Informational message. The scanner self-test has been performed successfully. 6-8 A-61169 July 2003