Kodak I840 User Guide - Page 73
Message Listing, Controlled Power-down Sequence, Message, Description, Action, Calibrate scanner now
UPC - 041778263082
View all Kodak I840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Message Listing Following is a list of messages and corrective actions you can take if one of the following messages appears on the Operator Control Panel. Most corrective actions can be found in this User's Guide; appropriate chapters are referenced. If one of the following messages appears, take the following action: • Determine whether or not the error can be addressed from the host system. • If the error cannot be addressed by the host system, attempt to clear the error by taking the action listed below. • If the prescribed action(s) does not clear the error, initiate a controlled power-down sequence: Controlled Power-down Sequence 1. Wait for all information currently held in the buffer to be transferred to the host system. 2. Turn off the scanner. 3. Wait 30 seconds. 4. Turn the scanner back on. If the error condition is not cleared after using the controlled power-down sequence, call Service. Message Message Action Message Action Message Action Message Action Description Calibrate scanner now You must calibrate the scanner now. See Chapter 3, Operator Control Panel Functions for calibration procedures. Calibrate scanner soon Calibrate the scanner when the current batch has completed. See Chapter 3, Operator Control Panel Functions for calibration procedures. Calibration failed Perform a controlled power-down sequence and recalibrate the scanner. Be sure you are using the correct calibration target. Clean the imaging guides. See Chapter 3, Operator Control Panel Functions for the correct calibration target. If the message persists, call Service. Calibration succeeded Informational message. The scanner has been successfully calibrated. A-61169 July 2003 6-5