Konica Minolta Fujitsu fi-7180 Operation Guide - Page 184
Settings Related to Scanning
View all Konica Minolta Fujitsu fi-7180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
Chapter 9 Operational Settings 9.5 Settings Related to Scanning Adjusting the Position to Start the Scan [Offset/Vertical magnification Adjustment] When the output position of the scanned image is not correct or the image appears shortened/elongated (vertically), adjust the offset and the vertical magnification in the following procedure. ATTENTION Normally, you should not have to make any adjustments as the factory default settings are configured at appropriate values. 1 Start up the Software Operation Panel. For details, refer to "9.1 Starting Up the Software Operation Panel" (page 163). 2 From the listing on the left, select [Device Setting] and click the [Offset] button. 3 Adjust the level of offset/vertical magnification as needed. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Offset Setting Description Unit Select [Flat bed] (fi-7260/fi-7280), [ADF (front)] or [ADF (back)] as the target for offset adjustment. Main Adjusts the horizontal (width) offset. The value can range from -2 to +2 mm (in increments of 0.5). Sub Adjusts the vertical (length) offset. The value can range from -2 to +2 mm (in increments of 0.5). Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 184