Konica Minolta Fujitsu fi-7180 Operation Guide - Page 186
T: top = 0 to 15 mm, B: bottom = -7 to 7 mm
View all Konica Minolta Fujitsu fi-7180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
Chapter 9 Operational Settings 3 Specify the width of each margin to fill in: top/bottom/left/ right. ADF T T: top = 0 to 15 mm B: bottom = -7 to 7 mm R: right = 0 to 15 mm L Image R L: left = 0 to 15 mm FB (fi-7260/fi-7280) T: top = 0 to 15 mm B B: bottom = 0 to 15 mm R: right = 0 to 15 mm L: left = 0 to 15 mm (in 1 mm increments) The specified area is filled in white or black, according to the background color. ATTENTION Note that if the target range of Page Edge Filler is too wide, some characters near the edge may appear missing. HINT The color of the background is normally white. You can change the background to black in the scanner driver. For details, refer to the scanner driver's Help. Depending on the value you specify, the bottom edge is filled in as follows: - 1 to 7 mm Fills the margin in white, from the detected page bottom. - -1 to -7 mm Outputs the image without filling in the margin. "Detected page bottom" refers to the bottom edge of the scanned document detected by the scanner. This setting can also be configured in the scanner driver. In that case, Page Edge Filler of the scanner driver is used on the output image. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 186