Konica Minolta MGI iFOIL S Printing Press iFOILs User Manual - Page 59

iFOIL S 7.Machine error code and troubleshooting 21 Gap adjustment active Automatic height adjustment system in progress Wait until height adjustment finish 22 Power control heater Error on heater power control error system Switch off and on the machine Check the wiring of the heater power control Check the heating lamps 23 Stacker full Bottom limit switch is reached Remove substrates from the stacker Move up the stacker plate 25 PLC Error Error on the PLC Switch machine off and on again. Check the power supply of the PLC ; If there is still the error, reinstall the PLC firmware 51 Servo error main motor Error at the servo drive of main drive motor Check servo drive in switch cabinet for error. Switch machine off and on again. If error occurs repeatedly, call service Thermo-Transfer 52 drum right side not closed The heating roller is not closed at the back side. Check the heating roller jacks for correct function. Check the air circuit for correct function Thermo-Transfer 53 drum left side not closed The heating roller is not closed at the front side. Check the heating roller jacks for correct function. Check the air circuit for correct function Thermo-Transfer 54 drum right side not open The heating roller is not opened at the back side. Check the heating roller jacks for correct function. Check the air circuit for correct function Thermo-Transfer 55 drum left side not open The heating roller is not opened at the front side. Check the heating roller jacks for correct function. Check the air circuit for correct function Thermo-Transfer 56 drum alarm temp. too high Temperature for the heating roller is out of range. Machine was stopped. Check heating lamp for correct function. Check the function of the infrered temperature sensor. Check the temperature settings Thermo-Transfer 57 drum alarm temp. too low Temperature for the heating roller is out of range. Machine was stopped. Check heating lamp for correct function. Check the function of the infrered temperature sensor. 58 Thermo-Transfer drum warning temp. too high Temperature for the heating roller is out of range. Machine runs, until temperature alarm limit is reached. Check heating lamp for correct function. Check the function of the infrered temperature sensor. 59 Thermo-Transfer drum warning temp. too low Temperature for the heating roller is out of range. Machine runs, until temperature alarm limit is reached. Check heating lamp for correct function. Check the function of the infrered temperature sensor. 60 Paper jam ThermoTransfer drum Paper jam before or under heating roller Remove the jammed paper Check the papar path ; if there is no issue User Manual 59