Konica Minolta MGI iFOIL S Printing Press iFOILs User Manual - Page 60
Check the internal heating lamp
View all Konica Minolta MGI iFOIL S Printing Press manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
iFOIL S 7.Machine error code and troubleshooting Sheet length too 61 short or format not correct Sheet length is too short compared Set the length value on 3DSHM to the setted value on 3DSHM to the sheet length 62 Sheet distance too short Sheets are too close to each other Increase the distance between sheets on the feeder 63 Main heater thermal fuse released Thermal protection fuse for the heating roller was released. Check fuse: shut down the machine and wait for cooling down of the heating roller ; If it is defective, replace it. 72 Paper jam on outfeed belt The sheet control sensor at outfeed of the machine signalized an error. Sheet is jammed on outfeed belt Remove jammed paper from the outfeed belt Check the papar path ; if there is no issue 73 Servo main motor no The machine loose the reference ref. point position Do the homing operation and press the run button. 74 Heaters warming up The heating roller is warming up Wait until the temperature is reached 75 Paper jam stacker Jammed paper at the exit Remove the jammed paper Check the papar path ; if there is no issue Check if there is no mechanical 76 Drive fault, broken belt or misalignment Motor default Broken tooth belt The infeed or outfeed belt is shifted problem Check the tooth belts ; change if broken Check the infeed and outfeed belts centering and tension ThermoTransfer 77 Drum, ext. temp. sensor fault The front side temperature sensor has a default Check the external heating lamp Check the front side temperature sensor ThermoTransfer 78 Drum, int. temp. sensor fault The back side temperature sensor has a default Check the internal heating lamp Check the back side temperature sensor 80 Heaters cooling down Wait until the temperature is The heating roller is cooling down reached 101 Servo error film infeed roller Error on servo drive of tension-in roller Check servo drive in switch cabinet for error. Switch machine off and on again. 102 Servo error film pull out roller Error on servo drive of tension-out roller Check servo drive in switch cabinet for error. Switch machine off and on again. 103 Film control 1 unwinding The film control sensors at foil unwinding unit (if foil unwinding control sensors are switched ON) Check the unwinding roles for foil running, or if foil is empty and clear the problem. 104 Film control 2 unwinding The film control sensors at foil unwinding unit (if foil unwinding control sensors are switched ON) Check the unwinding roles for foil running, or if foil is empty and clear the problem. 106 Infeed rollers right side not closed The infeed rollers are not closed at the back side. Check the infeed roller jacks for correct function. Check the air circuit for correct function User Manual 60