Home » Kyocera Manuals » Multifunction Devices » Kyocera KM-5230 » Manual Viewer

Kyocera KM-5230 4230-5230 Instruction Handbook - Page 171

Messages

Get Kyocera KM-5230 PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 171 highlights

MESSAGES q When the messages below are displayed: When any of the messages below appear on the touch panel, take the action indicated. Message "Close xxx cover." Action The cover displayed is open. Close it/them securely. Page __ "Add paper in drawer." There is no paper in the drawer displayed. Load paper of size indicated. 31 "Set drawer." "Set the paper drawer." "Push Fixing unit until it stops" One of the drawers is not closed properly. Pull it out, and push it back in all the way. The fixing unit is not set securely. Open the front cover and the left cover and push the fixing unit securely into its original position. 33 185 "Drawer inoperable. Call for service." The drawer currently in use is out of order and cannot be used for the moment. Contact your service representative as soon as possible. __ Continue copying using another drawer. "Check paper size." There is no paper of the appropriate size for the mode which has been __ set. Check the paper. "Reposition original or change drawer." The orientations of the original(s) and the paper selected are different. Change the orientation of the original(s). If the Start key is pressed without changing the orientation of the original(s), same-size copying will be 38 performed. "Reset all originals in feeder." Original(s) has not been fed correctly during feeding into the DF. Remove all originals and set them again. 38 "Reset all originals in feeder." An original is misfed inside of the DF. Remove the misfed original following the procedure, remaining the main switch ON ( | ). 187 "Cannot duplex copy on this size." Two-sided copying cannot be performed on small size paper like 51/2" x 81/2" or custom size. Change the paper size. 53 "Install duplex unit." Duplex unit has not been set correctly. Set it securely. __ "Duplex tray inoperable, call for service." "Ready to copy. Add toner to resume copying." "Add toner to resume copying." Problem in the duplex unit. 2-sided copying is not possible. Contact your __ service representative as soon as possible. There is not enough toner in the copier. Replace the toner cartridge immediately as only one copy at a time can be made. 172 There is not enough toner in the copier to make copies. Replace the toner cartridge immediately. 172 "Call for service." Open and close the front cover. If this message does not disappear, make a note of the "C" and numbers appearing with it, turn the main switch OFF __ (O), and contact your service representative. 166

Section	Page
INSTRUCTION HANDBOOK	1
CONTENTS	6
CAUTION LABELS	9
INSTALLATION PRECAUTIONS	12
PRECAUTIONS FOR USE	15
MAKING FULL USE OF THE MACHINE'S ADVANCED FUNCTIONS	18
NAMES OF PARTS	24
(1) Main body	25
(2) Operation panel	30
(3) Basic screen on the touch panel	31
PREPARATIONS	36
(1) How to load paper	36
1 Loading paper into the drawers	36
2 Loading paper into the deck	38
3 Loading paper into the stack bypass tray	39
SETTING ORIGINALS	42
1 Setting original(s) in the DF	42
Auto selection mode	44
2 Setting original(s) on the platen	44
BASIC OPERATION	46
Basic copying procedure	46
FUNCTIONS	52
(1) Enlargement/reduction	52
1 Auto magnification selection mode	52
2 Zoom copy mode	53
3 Standard zoom mode	53
4 Size zoom mode	54
5 XY Zoom mode	55
(2) Copy quality selection	56
(3) Interrupt copying	57
(4) Two-sided copying from various originals [Two-sided copy]	58
(5) Making a margin space for binding [Margin mode]	61
(6) Printing page numbers to copy [Print page numbers]	65
(7) Copying two-page originals as separate pages [Page separation copy mode]	67
(8) Making copies with clean edges [Border erase mode]	68
(9) Making covers or insert sheets among the copies [Sheet copy]	70
1 Submodes	70
2 Combination of modes	74
3 How to make copies in the sheet mode	76
(10) Making copies onto transparencies [Presentation mode]	80
(11) Feeding a paper as a transparency + backing sheet mount [Transparency + backing sheet modes]	83
(12) Making image overlay [Form overlay]	86
(13) One copy from two or four originals [Combine copy]	88
(14) Booklet from book originals [Booklet + cover copy mode]	91
(15) Weekly magazine from two-sided/one-sided originals [Booklet copy]	93
(16) Copying and stitching into booklet (sheet originals) [Stitching mode]	96
(17) Inverting black and white [Invert copy]	100
(18) Making mirror image copies [Mirror image mode]	100
(19) Sorting automatically [Sort copy]	101
(20) Memorizing frequency used settings [Program mode]	102
1 How to register settings	102
2 Calling up a program	103
(21) Recall mode	104
(22) Setting change function	105
(23) Rotate copy	106
(24) Energy saver function	106
(25) Auto shut-off function	107
APPLICABLE COPY MODES	108
(1) Reserving another copy while copying is performed [Job reservation]	108
1 Reserve job	109
2 Changing the setting contents of the reserved job	110
3 Clearing the reserved job	111
4 Changing the order of reserved job	112
(2) Copying various originals at a time [Job build function]	113
1 Memory copy from DF and platen	113
Copying of originals in large quantity	113
Printing size standardization	113
Choose size	113
2 Two-sided copies from one-sided and two-sided mixed originals	117
Finishing like originals [Print as original]	117
Two-sided copies from all originals [Duplex all originals]	117
Copying desired page on the front side [Chapterize]	117
3 Batch copy from platen	121
Only sheet originals	121
Only book originals	121
Sheet & book originals	121
COPIER MANAGEMENT	125
(1) Copy management	125
1 About the copy management mode	125
2 How to make settings in the copy management mode	127
3 How to make the various settings	127
Registering new Dept. codes	127
Deleting Dept. codes	129
Altering limits	130
Clearing copy counts	131
Viewing copy counts	132
Printing of copy management report	132
Turning copy management ON/OFF	133
4 Making copies when copier is in copy management mode	133
(2) Week timer	134
1 About the timer function	135
2 How to make settings in the timer mode	136
3 How to make settings for the various functions	137
Setting the time	137
Programming the week timer	137
Cancelling the timer function	139
Turning the timer ON/OFF	139
4 Making copies after copier has been stopped by timer	140
(3) The default settings	140
Copy default setting	141
How to make settings in the copy default setting mode	144
How to set each mode	145
1 Exposure mode	145
2 Exposure steps	146
3 Toner economy mode	146
4 Auto exposure adjustment	146
5 Manual exposure adjustment	147
6 Quality	147
7 Output form	148
8 Paper selection	148
9 Job Programming	148
10 Default drawer	148
11 Zoom mode	149
12 Copy limit: with # keys	149
13 Custom border erase size	150
14 F&B p. margin	150
15 Drawer for insert sheet	150
16 Drawer for cover sheet/stitch.	151
17 Rotate sort	151
18 Create shortcut (#1, #2)	152
19 Customize GUI #1 - #5	152
How to finish the copy default setting	153
Machine default setting	153
How to set the machine default setting mode	155
How to set each mode	156
1 Un-fixed size from bypass	156
2 Automatic drawer switching	157
3 Drawer paper size	158
4 Special paper	158
5 APS for special paper	158
6 Key sound	159
7 Auto preheat time	159
8 Auto shut-off time	159
9 Management code change: with # keys	160
10 Auto shut-off	160
How to finish the machine default setting	160
(4) Selection of touch panel language	161
OPTIONAL EQUIPMENT	162
(1) a. Finisher	162
b. Booklet stitcher	162
(2) Key counter	165
(3) I/F kit	166
(4) Memory copy board	166
(5) MMD host monitoring system device	166
MESSAGES	171
When the messages below are displayed:	171
REPLACING THE TONER CARTRIDGE	177
WHEN PAPER MISFEEDS	179
(1) Misfeed location indicators	179
(2) Cautions	179
(3) Removal procedures	182
TROUBLESHOOTING	195
CLEANING THE COPIER	201
SPECIFICATIONS	203
ABOUT 52 PPM COPIER	206

Match case Limit results 1 per page

MESSAGES

●

When the messages below are displayed:

When any of the messages below appear on the touch panel, take the action indicated.

Action

Page

Message

The cover displayed is open. Close it/them securely.

“Close xxx cover.”

There is no paper in the drawer displayed. Load paper of size indicated.

“Add paper in drawer.”

One of the drawers is not closed properly. Pull it out, and push it back in

all the way.

The fixing unit is not set securely. Open the front cover and the left cover

and push the fixing unit securely into its original position.

185

“Set drawer.”

“Set the paper drawer.”

“Push Fixing unit until it stops”

The drawer currently in use is out of order and cannot be used for the

moment. Contact your service representative as soon as possible.

Continue copying using another drawer.

“Drawer inoperable.

Call for service.”

There is no paper of the appropriate size for the mode which has been

set. Check the paper.

“Check paper size.”

The orientations of the original(s) and the paper selected are different.

Change the orientation of the original(s). If the Start key is pressed without

changing the orientation of the original(s), same-size copying will be

performed.

“Reposition original or

change drawer.”

Original(s) has not been fed correctly during feeding into the DF. Remove

all originals and set them again.

“Reset all originals in feeder.”

An original is misfed inside of the DF. Remove the misfed original

following the procedure, remaining the main switch ON ( | ).

187

“Reset all originals in feeder.”

Two-sided copying cannot be performed on small size paper like 5

1/2

" x

1/2

" or custom size. Change the paper size.

“Cannot duplex copy on this size.”

Duplex unit has not been set correctly. Set it securely.

“Install duplex unit.”

Problem in the duplex unit. 2-sided copying is not possible. Contact your

service representative as soon as possible.

“Duplex tray inoperable,

call for service.”

There is not enough toner in the copier. Replace the toner cartridge

immediately as only one copy at a time can be made.

172

“Ready to copy.

Add toner to resume copying.”

There is not enough toner in the copier to make copies. Replace the toner

cartridge immediately.

172

“Add toner to resume copying.”

Open and close the front cover. If this message does not disappear, make

a note of the “C” and numbers appearing with it, turn the main switch OFF

(O), and contact your service representative.

“Call for service.”

166