Kyocera KM-5230 4230-5230 Instruction Handbook - Page 218

SAFETY OF LASER BEAM 1. Safety of laser beam This copier has been certified by the manufacturer to Class 1 level under the radiation performance standards established by the U.S. DHHS (Department of Health and Human Services) in 1968. This indicates that the product is safe to use during normal operation and maintenance. The laser optical system, enclosed in a protective housing and sealed within the external covers, never permits the laser beam to escape. 2. The CDRH Act A laser-product-related act was implemented on Aug. 2, 1976, by the Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration (FDA). This act prohibits the sale of laser products in the U.S. without certification, and applies to laser products manufactured after Aug. 1, 1976. The label shown below indicates compliance with the CDRH regulations and must be attached to laser products marketed in the United States. On this copier, the label is on the rear. 3. Optical unit 4230 COPYING MACHINE MACHINE No. XV37 MANUFACTURED 33T1 C US THIS PRODUCT COMPLIES WITH 21 60 Hz CFR CHAPTER 1,SUBCHAPTER J. 120 V 10.5 A LISTED I.T.E. U2 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 2-28 1-CHOME TAMATSUKURI CHUO-KU OSAKA JAPAN MADE IN JAPAN (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION Double pole / neutral fusing. ATTENTION Double pÔle / fusible sur le neutre. This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. 5230 COPYING MACHINE MACHINE No. XW37 MANUFACTURED 33T1 C US THIS PRODUCT COMPLIES WITH 21 60 Hz CFR CHAPTER 1,SUBCHAPTER J. 120 V 10.5 A LISTED I.T.E. U2 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 2-28 1-CHOME TAMATSUKURI CHUO-KU OSAKA JAPAN MADE IN JAPAN (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION Double pole / neutral fusing. ATTENTION Double pÔle / fusible sur le neutre. This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. When checking the optical unit, avoid direct exposure to the laser beam, which is invisible. Shown at left is the label located on the cover of the optical unit. 4. Maintenance For safety of the service personnel, follow the maintenance instructions in the other section of this manual. 5. Safety switch The power to the laser unit is cut off when the front cover is opened. 213