Lantronix PremierWave XC PremierWave XC - Command Reference - Page 13
Login Level Commands, Commands and Levels
View all Lantronix PremierWave XC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3: Command Line Interface Commands at the login level (see Figure 3-3 Login Level Commands below) do not affect current configuration settings and are not displayed initially. If you type ?, you will see the login sub- commands. These commands provide diagnostic and status information only. Figure 3-3 Login Level Commands >? clear events clrscrn ping pint show history trace route > clear faults exit ping show trace route enable Note: To configure the PremierWave XC, you must be in the enable level and any of its sub-levels. Figure 3-4 below shows the enable level commands. >enable Figure 3-4 Enable Level Commands #? autoshow interfaces auto show processes clrscrn configure connect connect line device disable dns email exit filesystem gateway kill ssh kill telnet line ping ping ping relay output reload reload factory defaults route show show history show interaces show ip sockets show processes show sessions ssh ssh ssh ssl telnet telnet trace route trace route tunnel write xml # See the Chapter 5: Commands and Levels at the end of this document for a complete list of levels, commands, and descriptions. PremierWave XC Command Reference 13