LiftMaster SL595 SL595 Manual - Page 16
Program Settings (dip Switch S1), Timer-to-close Enable, Slide/swing, Right/left Operation - slide gate operator
View all LiftMaster SL595 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
PROGRAM SETTINGS (DIP SWITCH S1) NOTE: For all S1, S2 and S4 switch settings to take effect, the Save Mode switch must be set to the off position. TIMER-TO-CLOSE ENABLE TIMER-TO-CLOSE This switch enables the auto close timer. The Timer-to-Close feature works in conjunction with the potentiometer located on the board. TIMER-TO-CLOSE ENABLED TIMER-TO-CLOSE DISABLED SAVE RT SW TTC SAVE RT SW TTC S1 S1 ON ON ON 1 2 34 ON 1 2 34 LT SL LT SL (Factory Default) SLIDE/SWING This switch selects slide or swing gate operation, in order to optimize gate behavior for specific application. SL = Slide • SW = Swing RIGHT/LEFT OPERATION This switch selects the gate opening direction, to the left or to the right. Right/Left operation is determined from the inside of fence looking out. "SAVE" SWITCH This switch stores all settings into memory and locks out changes. NOTE: For any programming changes to take effect this switch must be in OFF position. When switch is ON, no settings can be changed. PROGRAM SETTINGS (DIP SWITCH S2) Max. = 180 sec Min. = 0 sec TTC TTC TTC SL SW SL SW SL SW LT RT LT RT LT RT SWING GATE S1 ON ON 1 2 34 LEFT HAND S1 ON ON 1 2 34 LOCKED S1 ON APEMs ON 1 2 34 SAVE SAVE SAVE TTC TTC TTC SL SW SL SW SL SW LT RT LT RT LT RT SLIDE GATE S1 ON ON 1 2 34 (Factory Default) RIGHT HAND S1 ON ON 1 2 34 (Factory Default) UNLOCKED S1 ON ON 1 2 34 (Factory Default) SAVE SAVE SAVE MAGLOCK ENABLE This switch enables the maglock feature. On an open command there will be a half second delay after the maglock relay is released before the motor starts. WARNING ENABLE This switch enables the gate "in motion" alarm feature. The alarm will beep 3 seconds prior to movement and throughout movement. 16 MAG MAG WARN WARN MAGLOCK ENABLED S2 ON ON 1 2 34 WARNING ENABLED S2 ON ON 1 2 34 PH OPED PH OPED PH CLED PH CLED MAG WARN MAG WARN MAGLOCK DISABLED S2 ON ON 1 2 34 (Factory Default) WARNING DISABLED S2 ON ON 1 2 34 (Factory Default) PH OPED PH OPED PH CLED PH CLED