LiftMaster SL595 SL595 Manual - Page 18
Radio Receiver, Programming The Radio Receiver
View all LiftMaster SL595 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
RADIO RCVR. R1 R2 R3 R4 RADIO RECEIVER All inputs are normally open and momentary, except the stop (N.C.). The following instructions are based upon UL325, and include recommendations for significant increase in safety. We strongly recommend that you follow the UL guidelines presented throughout the manual. Refer to instructions shipped with optional control devices for mounting, wiring, programming and adjustment. When using a remote control or Single Button Control Station in lieu of the Soft Open feature, perform the following modifications to the operator: 1. Remove the green wire from R4 of the radio block and mount the wire to terminal block TB1 position 6. 2. Move the brown wire on Terminal Block TB1 position 6 (from radio block R4) to Terminal Block TB1 position 1. Receiver 4 3 2 1 Operator Terminal R4 Relay Control R3 R2 24 Vac Power R1 24 Vac Accessory Power can be found at terminals R1 and R2 located on radio terminal block. The LiftMaster Radio Receiver comes pre-wired to the operator WARNING • Remove the brass antenna from the accessary box and screw it onto the "F"-connector provided on the side of the gate operator. CAUTION NOTE: The radio receiver is wired in the factory for single button control to open and close the gate. Remote control devices are not provided. WARNING Connector Antenna Accessory Tray WARNING To prevent possible SERIOUS INJURY or DEATH from electrocution: PROGRAMMING THE RADIO RECEIVER Set Security Mode • Be sure power is not connected BEFORE installing the receiver. To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: The Universal Receiver can be used with up to 15 rolling code • ALWAYS keep remote controls out of reach of children. AVERTISSEMENT remote controls or passwords in HIGH security mode. Alternately, it can be used with up to 31 of any type remote control in NEVER permit children to operate or play with remote controls. NORMAL security mode, including any combination of rolling • Activate gate or door ONLY when it can be seen clearly, is code, billion code, or dip switch remotes. properly adjusted and there are no obstructions to door AVERTISSEMENT The jumper must be set at the HIGH position for the receiver to travel. operate in HIGH security mode. It must be set at NORMAL • ALWAYS keep gate or garage door in sight until completely position to operate at the NORMAL mode (Figure 1). closed. NEVER permit anyone to cross path of moving gate or ATTENTION When changing from NORMAL to HIGH security mode, any previous remote control codes must be erased. Repeat Steps 2 door. and 3 in the Programming Section (page 19) to reprogram the receiver for each remote control remote control in use. WARNING The receiver is factory set at HIGH. AVERTISSEMENT To prevent possible SERIOUS INJURY or DEATH, the use of Set Output Duration For commercial applications, the receiver can be set for either CAUTION CONSTANT OPERATION on residential openers is PROHIBITED. constant or momentary closure on the output contacts. Use of constant closure is prohibited on residential garage door openers because it overrides the safety reversal devices. Figure 1 Security Mode Terminals Jumper Security Mode Terminals Jumper With the jumper in the "M" (Momentary) position, the contacts will close for 1/4 second regardless of the length of radio transmission. With the jumper in "C" (Constant) position, the contacts will stay closed as long as the radio continues transmitting (Figure 2). The receiver is factory set at M. AVERT ADVERTENCIA RECAUCIÓN ADVERTENCIA AVERT HIGH SECURITY MODE NORMAL SECURITY MODE 18 ADVERTENCIA