Maytag MED6300TQ Use and Care Guide - Page 11

3, Connect ground wire (green or bare) of power supply cord to external ground conductor screw. Tighten screw. Strip 5" (12.7 cm) of outer covering from end of cable, leaving bare ground wire at 5" (12.7 cm). Cut 1Vd' (3.8 cm) from 3 remaining wires. Strip insulation back 1" (2.5 cm). Shape ends of wires into a hook shape. (12,Z When connecting to the terminal block, place the hooked end of the wire under the screw of the terminal block Ihook facing right), squeeze hooked end together and tighten screw, as shown. A. External ground conductor screw B. Neutral ground wire C. Ground wire (green or bare) of power supply cord D. _/4" ( 1.9 cm) U[ listed strain relief E. Center silver-colored terminal block screw [. Neutral wire twhite or center wire) 4, Connect the other wires to outer terminal block screws. Tighten screws. !! !! 1. Remove center silver-colored terminal block screw. 2. Remove neutral ground wire from external ground conductor screw. Connect neutral ground wire and place the hooked end (hook facing right) of the neutral wire (white or center wire) of direct wire cable under the center screw of the terminal block. Squeeze hooked ends together. Tighten screw. 5, Tighten strain relief screws. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold- down screw. 7. You have completed your electrical connection. Now go to "Venting Requirements." 4-wire connection: Direct Wire IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3 wire connections. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. D t _", A. Neutral ground wire B. £xternal glound conductor screw - Dotted line shows position of NEUTRAL ground wire before being rnoved to center silver-colored terminal block screw. C. Center silver-co/ore'd terminal block scre'w D. Neutral wire (white or center wire) E. _4" ( 1.9 cm) UL listed strain relic4