Maytag MED6300TQ Use and Care Guide - Page 13

3. Connect the other wires to outer terminal block screws. Tighten screws. !! !! Place the hooked end of the neutral wire (white or center wire) of direct wire cable under the center screw of terminal block (hook facing right). Squeeze hooked end together. Tighten screw. 4. Tighten strain relief screws. 5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold- down screw. 6. You have completed your electrical connection. Now go to "Venting Requirements." 3-wire connection: Direct Wire Use where local codes permit connecting cabinet-ground conductor to neutral wire. Direct wire cable must have 5 ft (1.52 rn) of extra length so dryer call be moved if needed. Strip 31/2'' (8.9 cm) of outer covering from end of cable. Strip insulation back 1" (2.5 cm). If using 3-wire cable with ground wire, cut bare wire even with outer covering. Shape ends of wires into a hook shape. _B.9c_ When connecting to the terminalblock, place the hooked end of the wire under the screw of the terminal block (hook facing right)s,queeze hooked end togetherand tightenscrew, as shown. I A. f xtemal ground conductor scre'w B. Neutral ground wire C. Ce'nter silver-colore'd tenTlinal block scre'w O. Neutral wire' (white or cente'r wire) E. _" (1.9 cm) U[ li_te'd strain relief Place the hooked ends of the other direct wire cable wires under the outer terminal screws (hooks facing right). Squeeze hooked ends togethen Tighten screws. !! !! block 1. Loosen or remove center silver-colored terminal block screw. 4. Tighten strain relief screw. 5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold- down screw. 6. You have completed your electrical connection. Now go to "Venting Requirements."