NEC PX-50VP1A 42PD2/50PD1 - Page 8

How to Attach Options to the Plasma Monitor You can attach your optional mounts or stand to the plasma monitor in one of the following two ways: * In the upright position. (See Drawing A) * Lay the screen face down (See Drawing B). Lay the protective sheet, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen face. Drawing A This device cannot be used or installed without a separate Tabletop Stand or other optional mounting accessory. For proper installation it is strongly recommended to use a trained, NEC authorized serviceman. Failure to follow correct mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding your warranty. Drawing B Ventilation Requirements for enclosure mounting To allow heat to disperse, leave space between surrounding objects as shown in the diagram to the right. Pulling Out and Reinserting the 31mm (1.22") Retractable Feet The Retractable Feet are housed at 2 locations on the bottom surface of the main unit. 1. Grasp the end and pull out. 2. The feet will open automatically when your hand is re- moved. To house the Retractable Feet, close them and then continue to push them inside the main unit. Notice: * Installation of only the main unit is not possible. Be sure to use and install the main unit in conjunction with a stand or special unit. Note: RETRACTABLE FEET ARE FOR TEMPORARY USE ONLY AND ARE NOT INTENDED FOR PERMANENT INSTALLATION. MODEL # PX-42VPU1-ST STAND IS REQUIRED FOR PERMANENT TABLETOP INSTALLATION. REPLACE THE FEET WHEN YOU MOVE THE MONITOR. 8 50mm (1.97") Wall 50mm (1.97") 31mm (1.22") 45mm (1.77") 1 2