Netgear WN802Tv1 WN802T User Manual - Page 60
Configuring Repeater with Wireless Client Association
View all Netgear WN802Tv1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
RangeMax NEXT Wireless-N Access Point WN802T Reference Manual • If using DHCP, all wireless access points should be set to "Obtain an IP address automatically (DHCP Client)" in the IP Address Source portion of the Basic IP Settings menu. • That all wireless access points are using the same SSID, Channel, WEP authentication mode, if any, and encryption (WPA is not available in bridge modes). • That each Point-to-Point AP has the Multi-Point AP MAC address in its Remote AP MAC address table. • If Access Control has been enabled on the APs, verify that the Wireless Cards table (MAC Address List) for each AP is complete and accurate. 3. Verify connectivity across the LANs. • If you checked the Enable Wireless Client Association radio box on each AP, wireless clients will be able to use the AP. • A computer on any LAN segment should then be able to connect to the Internet or share files and printers with any other PCs or servers connected to any of the three LAN segments. • If Access Control Lists are enabled on the APs, only computers in the access control list will be able to use the AP. Note: You can extend multi-point bridging by adding a total of six WN802T APs configured in Point-to-Point mode to connect additional wireless LAN segments. Configuring Repeater with Wireless Client Association In this mode, the WN802T will operate as a Repeater only, and send all traffic to the remote wireless access point. You must enter the MAC address (physical address) of the remote wireless access point. 5-4 Advanced Wireless Bridging v1.0, August 2007