Netgear WN802Tv1 WN802T User Manual - Page 65

RangeMax NEXT Wireless-N Access Point WN802T Reference Manual • The computer with the wireless adapter may not have the correct TCP/IP settings to communicate with the network. Restart the computer and check that TCP/IP is set up properly for that network. The usual setting for Windows on the Network Properties is set to "Obtain an IP address automatically." • The wireless access point's default values may not work with your network. Check the wireless access point's default configuration against the configuration of other devices in your network. • For full instructions on changing the wireless access point's default values, see Chapter 2, "Installation and Configuration" and Chapter 3, "Wireless Security Settings". When I enter a URL or IP address I get a timeout error. A number of things could be causing this. Try the following troubleshooting steps. • Check whether other computers work. If they do, ensure that your computer's IP Address, Subnet Mask and Default Gateway settings are correct. If using a DNS Server, check the Primary and Secondary DNS Server Addresses. • If the computers are configured correctly, but still not working, ensure that the WN802T is connected and turned on. Connect to it and check its settings. If you cannot connect to it, check the LAN and power connections. • If the WN802T is configured correctly, check your Internet connection (DSL/Cable modem, etc.) to make sure that it is working. • Try again. • When entering configuration settings, be sure to click the Apply button before moving to another menu or tab, or your changes are lost. • Click the Refresh or Reload button in the Web browser. The changes may have occurred, but the Web browser may be caching the old configuration. Using the Reset Button to Restore Factory Default Settings The reset button on the rear panel of the WN802T has two functions: • Reboot: When pressed and released quickly, the WN802T will reboot (restart). Troubleshooting 6-3 v1.0, August 2007