Oki MICROLINE 390 TURBO Printer Handbook - Page 109

IBM Function Commands (ASCII, Decimal, Hexadecimal) Notes Automatic Line Feed Control n/360-inch Line Feed ASCII: ESC 5 Dec: 27 53 n Hex: 1B 35 n ASCII: ESC % 4 n Dec: 27 37 52 n Hex: 1B 25 34 n n/216-inch or n/180-inch Line Feed ASCII: ESC J n Dec: 27 74 n Hex: 1B 4A n Form Feed ASCII: FF Dec: 12 Hex: 0C Vertical Tab Set Vertical Tab Stops Set Form Length in Inches ASCII: VT Dec: 11 Hex: 0B ASCII: ESC B n1 n2 ··· nk NUL Dec: 27 66 n1 n2 ··· nk 0 Hex: 1B 42 n1 n2 ··· nk 00 ASCII: ESC C NUL n Dec: 27 67 0 n Hex: 1B 43 00 n n=Odd: Line feed automatically added to each CR (carriage return) n=Even: auto line feed turned Off OKI unique command. Prints data in buffer and executes a single n/360-inch line feed without changing line spacing. n=1 to 255 n=0: no line feed In PPR emulation, prints data in buffer and executes a single n/216-inch line feed: in AGM emulaiton, executes a single n/180-inch line feed, both without changing line spacing. Carriage Return determined by menu setting. n=1 to 255 n=0: no line feed Prints data in buffer and advances paper to next top of form. With Cut Sheet Feeder installed, will eject or insert paper depending on status of feeder. Print buffer data and move to next vertical tab stop. Sets vertical tab stops at specified lines. k=1 to 64: number of tabs n=1 to 255: line number where tabs is to be set Sets page length in inches. n=1 to 255 inches n=0: Command ignored This command cancels Skip Over Perforation setting. 102 Appendix D: Priner Commands