Onkyo TX-NR626 Owner's Manual English - Page 64

OSD Setup ■ On Screen Display ` On ` Off This preference determines whether operation details are displayed on-screen when an AV receiver function is adjusted. Even when "On" is selected, operation details may not be output if the input source is connected to an HDMI IN. ■ Language (North American models) ` English, Deutsch, Français, Español, Italiano, Nederlands, Svenska (European, Australian and Asian models) ` English, Deutsch, Français, Español, Italiano, Nederlands, Svenska (Taiwanese models) ` English, Deutsch, Français, Español, Italiano, Nederlands, Svenska, ʕ˖ This setting determines the language used for the onscreen menus. ■ Screen Saver ` 3min, 5min, 10min ` Off With this setting, you can set the time until the screen saver activates itself. Once active, the screen saver will go off and the screen will return to its previous state if the AV receiver is operated in any way. 7. Hardware Setup Tuner ■ AM/FM Frequency Step (North American and Taiwanese models) ` 10kHz/200kHz: ` 9kHz/50kHz: Select the frequency step according to your area. ■ AM Frequency Step (European, Australian and Asian models) ` 10kHz: ` 9kHz: Select the frequency step according to your area. For AM/FM tuning to work properly, you must specify the AM/FM frequency step used in your area. Note • When this setting is changed, all radio presets will be deleted. HDMI ■ HDMI CEC (RIHD) ` Off ` On Turn this setting on to allow Q-compatible components connected via HDMI to be controlled by the AV receiver (➔ page 16). Advanced Operations Note • When the setting is set to "On" and the menu is closed, the names of connected Q-compatible components and "RIHD On" are displayed on the AV receiver. "Search..." → "(name)" → "RIHD On" When the AV receiver cannot receive the name of the component, it is displayed as "Player*" or "Recorder*", etc. ("*" shows up and indicates the number of components, when two or more are received). • When an Q-compatible component is connected to the AV receiver via an HDMI cable, the name of the connected component is displayed on the AV receiver display. For example, while you are watching TV broadcasting, if you operate a Blu-ray Disc/DVD player (being powered on) with the remote control of the AV receiver, the name of the Blu-ray Disc/DVD player will be displayed on the AV receiver. • Set it to "Off" when a connected piece of equipment is not compatible or it is unclear whether the equipment is compatible or not. • If operation is not normal when set to "On", change the setting to "Off". • Refer to the connected component's instruction manual for details. • When the "HDMI CEC (RIHD)" setting is set to "On", the power consumption on standby mode slightly increases. (Depending on the TV status, the AV receiver will enter standby mode as usual.) • The Q control does not support HDMI OUT SUB. Use HDMI OUT MAIN instead. • When the source equipment is connected with the V connection, it may malfunction if "HDMI CEC (RIHD)" is set to "On". En-64 Operating procedure (➔ page 52)