Onkyo TX-NR626 Owner's Manual English - Page 70
Controlling Zone 2 Components, En-70
View all Onkyo TX-NR626 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Controlling Zone 2 Components ■ Operating on the AV receiver Input selector buttons ZONE 2 OFF MASTER VOLUME 1 To turn on Zone 2 and select an input source, press ZONE 2 followed by an input selector button within 8 seconds. Zone 2 turns on, the Z2 indicator lights on the AV receiver's display. To select the same source as the main room's, press ZONE 2 twice. "Z2 Sel: Source" appears on the AV receiver's display. 2 To turn off Zone 2, press OFF. The zone is turned off. ■ Operating on the remote controller To control Zone 2, you must press ZONE2 on the remote controller first. RECEIVER ZONE2 INPUT SELECTOR MUTING VOLR/X 1 Press ZONE2, then point the remote controller at the AV receiver and press RECEIVER. Zone 2 turns on, the Z2 indicator lights on the AV receiver's display. 2 To select an input source for Zone 2, press ZONE2, followed by an INPUT SELECTOR button. 3 To turn off Zone 2, press ZONE2, followed by RECEIVER. The zone is turned off. Adjusting the Volume for Zone 2 ■ Operating on the remote controller 1 Press ZONE2. 2 Use VOL R/X. ■ Operating on the AV receiver 1 Press ZONE 2 (the Z2 indicator on the AV receiver's display flashes). 2 Use MASTER VOLUME control within 8 seconds. If your Zone 2 speakers are connected to a receiver or integrated amplifier in Zone 2, use its volume control to adjust the volume. Muting Zone 2 ■ Operating on the remote controller 1 Press ZONE2 followed by MUTING. Advanced Operations Tip • To unmute, press ZONE2 followed by MUTING again. Zone can also be unmuted by adjusting the volume. Note • Only analog, NET or USB input source is output from the ZONE 2 LINE OUT jacks and ZONE 2 L/R terminals. • You cannot select different AM or FM radio stations for your main room and Zone 2. The same AM/FM radio station will be heard in each room. Namely, if you have selected an FM station for the main room, that station will also be output in Zone 2. • You cannot select different input selector NET or USB for your main room and Zone 2. Namely, if you have selected USB input selector for Zone 2, USB input selector will be selected in main room even if NET has been selected for main room. • BLUETOOTH cannot be selected as input selector in Zone 2. If you play audio from Bluetooth-enabled device in Zone 2, select "Z2 Sel: Source", and BLUETOOTH as input selector in Main room. • When Zone 2 is activated and its input selector is selected, the power consumption of standby mode slightly increases. • While Zone 2 is on, V functions will not work. • When setting the AV receiver to standby mode while Zone 2 is active, the Z2 indicator is dimly lit. • Activating Zones in the main room when the listening mode is set to Pure Audio (European, Australian and Asian models) will automatically switch it to Direct. En-70