Onkyo TX-NR626 Owner's Manual English - Page 68
Remote Controller Setup, 9. Lock Setup, En-68 - bluetooth pairing
View all Onkyo TX-NR626 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
■ Bluetooth This setting enables the AV receiver to pair with Bluetooth-enabled device. Status Press ENTER button to display "Now Pairing" and start pairing. Tip • If pairing setting is not set, "Ready" appears on-screen display. The name of the device paired with the AV receiver is displayed if pairing setting is set. • For details on the Bluetooth connection, refer to the instruction manual of the Bluetooth-enabled device. • The pairing can be done by holding down BLUETOOTH button on the AV receiver until BLUETOOTH indicator flashes. Note • This setting cannot be selected if you've selected NET or USB as input selector in Zone 2. Initial Setup If you skipped the initial setup wizard, for example on first-time use, you can reaccess it from here. See "Initial Setup" (➔ page 22). Note • This setting cannot be selected if the "Monitor Out" setting is set to "Sub". 8. Remote Controller Setup Remote ID ■ Remote ID ` 1, 2, or 3 When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate the AV receiver from other components, you can change its remote ID from "1", to "2" or "3". Note • If you do change the AV receiver's remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won't be able to control it with the remote controller. Changing the remote controller's ID 1 While holding down RECEIVER, press and hold down Q SETUP until the remote indicator lights (about 3 seconds). 2 Use the number buttons to enter ID 1, 2, or 3. The remote indicator flashes twice. Remote Mode Setup See "Looking up for Remote Control Codes" (➔ page 71). Advanced Operations 9. Lock Setup With this preference, you can protect your settings by locking the setup menus. ■ Setup ` Locked ` Unlocked When "Locked" is selected, the setup menus will be locked and you cannot change any setting. En-68 Operating procedure (➔ page 52)